Hi all,
I've been editing a very small GPS tracker, part of which is adding a little tag with the JTAG header on which can be snapped off after programming (to save weight! every milligram matters). However, when I try to set an area to exclude from pooling copper, it seems to draw a line with copper around it. Can anyone figure out what is wrong with it?
Aside from that, this should be the final version - if you notice any obvious errors, please mention!
Many thanks for your time.
Sparky
P.S. I cannot seem to upload the .brd file, so please find it here:
https://drive.google.com/file/d/0B49qTHagrsnFbk1PdWNfVWZKcGM/view?usp=sharing
I've been editing a very small GPS tracker, part of which is adding a little tag with the JTAG header on which can be snapped off after programming (to save weight! every milligram matters). However, when I try to set an area to exclude from pooling copper, it seems to draw a line with copper around it. Can anyone figure out what is wrong with it?
Aside from that, this should be the final version - if you notice any obvious errors, please mention!
Many thanks for your time.
Sparky
P.S. I cannot seem to upload the .brd file, so please find it here:
https://drive.google.com/file/d/0B49qTHagrsnFbk1PdWNfVWZKcGM/view?usp=sharing
Attachments
-
399.5 KB Views: 5