I want to use the ic driver ISO5500 the digikey part number is 296-34888-5-ND
I'm going to use it to drive a mosfet, not an igbt. The pwm signal is 3.3V and the output I want is 5V. Here are some of my questions:
- If I don't plan on using reset or fault signals, do I just not connect them or should I give it input supply voltage?
- I don't plan to have any negative voltages so both Vee-p and Vee-l are grounded, right?
- Lastly, what do I do with Ve (pin # 16) since this is mosfet not igbt?
I'm going to use it to drive a mosfet, not an igbt. The pwm signal is 3.3V and the output I want is 5V. Here are some of my questions:
- If I don't plan on using reset or fault signals, do I just not connect them or should I give it input supply voltage?
- I don't plan to have any negative voltages so both Vee-p and Vee-l are grounded, right?
- Lastly, what do I do with Ve (pin # 16) since this is mosfet not igbt?