I have been trying to get my arduino opla IOT kit to work for MONTHS...ive tried everything...downloaded create agent (with some issues along the way), downloaded the most current IDE, downloaded the newest wifi chip firmware, tried swapping out two sets of hardware, played endlessly with disassociating and re-associating my device on the cloud, made and remade variables, made and remade "things", tried a bunch of different sketches
no matter what i do, the sketch will appear to upload fine, BUT the device "bar" (ill call it) still says "device disconnected" and then "device reconnected" right before it finishes uploading
the serial monitor continues to say "connection to hillary's weather station failed, retrying in 500 milliseconds" over and over
nothing happens on my display carrier (ive tried opening the serial monitor at this point as well as touching the capacitive touch sensors)
by the way im trying to get the Temp, Hum, Pressure (something like that) sketch because it only involves built in sensors and built in display
no matter what i do, the sketch will appear to upload fine, BUT the device "bar" (ill call it) still says "device disconnected" and then "device reconnected" right before it finishes uploading
the serial monitor continues to say "connection to hillary's weather station failed, retrying in 500 milliseconds" over and over
nothing happens on my display carrier (ive tried opening the serial monitor at this point as well as touching the capacitive touch sensors)
by the way im trying to get the Temp, Hum, Pressure (something like that) sketch because it only involves built in sensors and built in display
Last edited by a moderator: