im trying to use the arduino OPLA IOT kit for home automation. the first project is to light up and control the color of the built in LEDs on the circular connector board.
so my code uploads to my arduino wifi mkr 1010... but when i run the program, the serial monitor shows this message:
Connection to "please work" failed
Retrying in "500" milliseconds
Connection to "please work" failed
Retrying in "500" milliseconds
(i named it "please work" after a few failed attempts)
dont understand, have been trying to figure this out myself...i just want the lights to turn on, and for the "dashboard" to control the color, blink speed, etc
so my code uploads to my arduino wifi mkr 1010... but when i run the program, the serial monitor shows this message:
Connection to "please work" failed
Retrying in "500" milliseconds
Connection to "please work" failed
Retrying in "500" milliseconds
(i named it "please work" after a few failed attempts)
dont understand, have been trying to figure this out myself...i just want the lights to turn on, and for the "dashboard" to control the color, blink speed, etc