integrated circuit

Received feedback that these parts are mysteriously over-heating when sent certain commands. When switched out with comparable parts in stock> No over-heating occured . Curious if this is impacting other users of this part or not. Is it a sign that this part could be counterfeit? Is there a bad...

Hello, I would like your suggestion on my first design Differential signal modulator [simulation attached]. Before jumping into design let me highlight my objective. I am differentiating a control signal of 1MHz and then modulating it with carrier frequency 15MHz(not limited to this specific...

Hello everyone. I came across while reading the opto-isolator technique used for electric isolation in embedded systems/ Integrated Circuits design that " Opto-isolator is not recommended for electric isolation in power applications IC's mainly due to its dV/dt sensitivity". So I would like to...

So i'm currently trying to take parts out of a Bluetooth speaker's circuit-board and find the Bluetooth module for a DIY project. I looked at the board and some ICs and tried looking them up to no avail. So How Do you read an IC or any other components on the board Or even find a schismatic...

Hello, I would need you guidance 'how galvanic isolation can be achieved in IC technology ? ' Thanks.

Hello, I am modulating control signal with Multivibrator circuit in CMOS technology. I use this formula (1/2.2RC) to find the frequency of modulated signal with multivibrator. But my simulation (result) and theoritical (calculation) of frequency is not matching. I am using CADENCE software tool...

Regarding CMOS analog IC layout, what are differences between DRC, DFM and DFR? What I understood during research: - DRC (Design Rule Check) checks if a laid out block follows technology rules what ensures dimensional precision and electrical parameters - DFM (Design For Manufacturing)...