1. maitrey

    Software to develop electrical wiring diagrams (Training)

    Hello Everyone, I am a young professional who has just started working in automation Industry as an electrical engineer and looking for a light scale software to develop electrical wiring diagrams for automation projects. My circuits mainly consists of PLC, HMI, IOs, E-Stop, Switches, Sensors...
  2. C

    Implementing some kind of motion sensor in place of NO/NC Push Button.

    Hi everyone! Firstly, I apologise if this is the wrong place to post! Over the last couple of years I've used a Weigl ProCommander PHX to control some event spaces from a series of push buttons. These have simply been wired from the PS+ to a terminal of a NO/NC push button and the other...
  3. J

    Looking for PIR Sensor/Ocupancy Sensor suggeations.

    I am in the process of building an automated lighting system for a bathroom in my home. The goal is to have the string of light turned on when the bathroom door is closed and nobody is in the room, and then have the lights turn off when someone enters the room. I want to have 3 failsafe's to...
  4. maitrey

    Communication Protocols :- DeviceNET, Profibus-DP and Profinet

    Hello, I am designing an automation solution where I have 40 Electrical valve acuators to connect my PLC. I am considering two types of actuators with different communication technology. Solution 1: Modbus TCP/IP Solution 2: DeviceNET, Profibus DP and Profinet (Not quite familiar with this)...
  5. G

    CRS Robot & C500C Wiring

    Hi all, I need a little help interpreting this schematic and doing some wiring for the System Input/Output plug that connects to the rear of the C500C CRS Robot Controller. My goal is to get the plug hooked up to an Opto22 R1 Controller. I'm guessing I'll have to use SNAP-ODC5 modules. If I...
  6. Timbat365

    Pallet shrink wrapper automation.

    Hi, I know this is a simple one for most of you but I’m quite new to this so please be gentle. I have an old pallet wrapper that I would like to automate. I still want to be able to use it in it’s current form so was going to start with a “manual/ auto” selector switch after the turntable has...
Top