ebeowulf17
- Joined Aug 12, 2014
- 3,307
How much current does the relay coil need?I think I was misunderstood. T1 grounds all the current through the relay coil when the gate receives a very small amount of current from the IC. I wanted to limit the current to T1 since it doesn't need much. I'm trying to limit current to or from the relay.
What is the hfe of your chosen transistor?
I always hear a rule if thumb saying that to use a bjt as a saturated switch you should set base current at 10% of your required current. You may not need to go that high depending on transistor specs, but why take chances?
If you're just worried about current through the MCU, you could use a logic level MOSFET instead of a bjt.