All About Circuits

Xjtag altium designer

Search Forums New Posts
xyat

Thread Starter

xyat

Joined Oct 29, 2024
1
Hi, I have a question. I need to test ATmega128 through XJTAG (Altium Designer) with another component that also has a BSDL file, and then connect this component to the ATmega (ideally 8 pins). Do you have any suggestions on which component I should use?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
H Altium .stackup from fab shows “Rigid (4L)” + “Flex (2L)” — is this a rigid-flex stack or a full 4-layer flex setup PCB Layout , EDA & Simulations 0
D Altium 25 Designer – Automatic ground plane cutout under SMT components (rules or scripting?) PCB Layout , EDA & Simulations 0
D Altium 25 Designer – Automatic ground plane cutout under SMT components (rules or scripting?) Software & IDEs 0
V Altium Designer: Component Clearance Constraint between Component on Top layer and Component on Bottom Layer PCB Layout , EDA & Simulations 0
V Altium Designer : Unable to see 3D bodies of the components in the 3D PCB PCB Layout , EDA & Simulations 3
Similar threads
Altium .stackup from fab shows “Rigid (4L)” + “Flex (2L)” — is this a rigid-flex stack or a full 4-layer flex setup
Altium 25 Designer – Automatic ground plane cutout under SMT components (rules or scripting?)
Altium 25 Designer – Automatic ground plane cutout under SMT components (rules or scripting?)
Altium Designer: Component Clearance Constraint between Component on Top layer and Component on Bottom Layer
Altium Designer : Unable to see 3D bodies of the components in the 3D PCB

You May Also Like

Top