I measured the voltage with the coil connected to circuit the results were same

Okay, then scope the voltage on the gate of the upper and lower fet on the same side.

 

Okay, then scope the voltage on the gate of the upper and lower fet on the same side.

Yeah here In high side I got a square wave with vmax=12 and low side I got v max =5
Even though this is weird
The gate threshold voltage of irfz44n is 4 v so this shouldn't affect ,right?

 

The gate threshold voltage of irfz44n is 4 v so this shouldn't affect ,right?

The threshold voltage is where the FET just begins to conduct (microamps). You need a considerably higher Vgs to turn a FET on fully.

 

The threshold voltage is where the FET just begins to conduct (microamps). You need a considerably higher Vgs to turn a FET on fully.

Thanks bro

 

Hey Friends
I'm creating wireless energy transfer circuit for that I'm using inverter circuit to generate 150 kHz square wave signal.I have attached the circuit diagram.When i assembled the circuit,I gave 12 V DC power supply.However at the output i got a square wave of 6 V max Voltage.This means there is voltage drop across the mosfets. View attachment 123360 Please note I have used Mosfet IRFZ44N in the circuit and not IRLZ44n.
Please tell me how to get a square voltage with 12v max voltage

SO GOOD!

 

Hey Friends
I'm creating wireless energy transfer circuit for that I'm using inverter circuit to generate 150 kHz square wave signal.I have attached the circuit diagram.When i assembled the circuit,I gave 12 V DC power supply.However at the output i got a square wave of 6 V max Voltage.This means there is voltage drop across the mosfets. View attachment 123360 Please note I have used Mosfet IRFZ44N in the circuit and not IRLZ44n.
Please tell me how to get a square voltage with 12v max voltage

Hi,
I'm a student doing a project on wireless power transfer. Is it possible you can guide me on how to do this circuit?

 

Okay, then scope the voltage on the gate of the upper and lower fet on the same side.

Hi,
I'm a student doing a project on wireless power transfer. Is it possible that you could guide me on how to build this particular circuit?