Greetings!
Stupid question. I'm using a stepper motor to drive a teeter-totter for a Halloween decoration. My wife wants it to start up on motion. The driver I have returns to "off" on re-energization, so I'm planning on leaving the driver on and set to speed and using a motion detector to drive a relay to open the 4 wire stepper leads. Would this cause damage to the driver (all pulsed up and no where to go)?
The motor and controller in question:
Stepper Motor Driver Control Board and 8mm 6.3mm 57 Stepper motor Reversal/Pulse/Speed Regulation/Module/Speed Display
https://www.aliexpress.com/item/3256801492807703.html
Thanks!
Stupid question. I'm using a stepper motor to drive a teeter-totter for a Halloween decoration. My wife wants it to start up on motion. The driver I have returns to "off" on re-energization, so I'm planning on leaving the driver on and set to speed and using a motion detector to drive a relay to open the 4 wire stepper leads. Would this cause damage to the driver (all pulsed up and no where to go)?
The motor and controller in question:
Stepper Motor Driver Control Board and 8mm 6.3mm 57 Stepper motor Reversal/Pulse/Speed Regulation/Module/Speed Display
https://www.aliexpress.com/item/3256801492807703.html
Thanks!