I am looking for a module pcb that i can use as a wifi access point must be power over ethernet with rj45 connection for input do you have anything or can you recomend anything, thanks Lee

 

Some Wifi routers can be configured to work as an access point. I have done this using a Linksys WAG200G router. If you have a spare router try Googling using that model router as an access point. (That is how I found out how to configure it.)

Les.

 

Thanks Les but was just looking for a small pcd board with everything on it for a project

 

Take a look at the:

“MakerFocus ESP8266 ESP-01 Serial Wireless WiFi Transceiver Receiver Module“

This module can be configured as a wireless access point. That’s the Amazon description, so you should be able to find it on Amazon.com with the description.

 

Thanks djsfantasi, any ideas if i can get these with the rj45 connection for the poe already on them? Lee

 

Nope

 

djsfantasi thanks anyway.

 

I use these to power things via POE..
https://www.newegg.com/tp-link-tl-poe150s-poe-injector/p/N82E16833997219
https://www.ebay.com.au/itm/POE-Inj...m3b31a3fde9:g:ffEAAOSwbINc4Ig6&frcectupt=true
You could quite well fit the ESP8266 board inside the case. And still the the Ethernet port usable.

 

Actually, I found the boxes I use.
The TP-LINK POE splitter is a TL-POE10R

and you can use the TP-LINK TL-WR703N flashed as an AP.
https://openwrt.org/toh/tp-link/tl-wr703n

They are quite hackable!

 

Dendad thats the sort of thing i am looking at thanks, just need the board to turn into an AP

 

I hope it helps

 

Dendad thanks its a great start