I found the Gerber files for PCB used to control a Universal Motor from an old washing machine HERE.
This is the finished article:
But as you can see, the Triac exploded when I applied 240VAC.
There is the circuit diagram:
I'd really appreciate any light you could guys could throw on the subject.
FYI: I didn't have the correct CAP for C10 (I used 47n instead of 100n) could that have caused the failure?
This is the finished article:
But as you can see, the Triac exploded when I applied 240VAC.
There is the circuit diagram:
I'd really appreciate any light you could guys could throw on the subject.
FYI: I didn't have the correct CAP for C10 (I used 47n instead of 100n) could that have caused the failure?