I have an old single phase 1/2hp 110v capacitor start motor that came with my clausing 4800 lathe, the motor has 4 wires sticking out, no capacitor and came with a switch with a ton of connection points, i have identified one of the winding which I assume is the run since the resistance is fairly low but i am lost as how yo wire this sucker and what size capacitor I need. A1 and A2 have 1.4 ohms on the 200 ohm setting, the centrifugal switch wire is obviously the one coming off the switch, the unlabeled wire is a mystery, its got around 1 million ohms to the centrifugal switch wire when the centrifugal switch is closed, and is infinite otherwise, and this big switch makes no sense, its labeled as a 1ho switch which probably isnt a problem, it has only the line and neutral wire and no ground
Attachments
-
1.1 MB Views: 23
-
1.7 MB Views: 24
-
1.6 MB Views: 23
-
1.9 MB Views: 23
-
1.6 MB Views: 24
-
1,022.3 KB Views: 24