I just need to ID two resistors 22Ω and 10KΩ, both 0603 packages for the micro controller circuit attached. Aside from the Atmega32u4 the other major component is a MPU6050 gyro chip. My question is do I need thin film resistors or would thick film suffix from what can be seen from the information provided. Also regarding the power rating of the resistors R1, R4, R8 and R9 at the four FET's for the motors, this being a quad copter flight control board. From my extremely rudimentary electronics knowledge I assume that these are pull down resistors to prevent a floating voltage at the micro controller pin. How would I work out an appropriate power rating for these resistors please. The two 22Ω are just I assume in the data lines and only carry very negligible current so what might a suitable voltage and power rating for these as well. Thanks to anyone that may be able to assist me.
Attachments
-
295.8 KB Views: 7