Hi, I am a newbe, I do have some electronic back ground and experiance, but relatively new to this
arena, so I have a pro mini controller, and two apc220 Transcievers. I have configured the two
rf modules with accompaning software (RF Magic), they are both set the same and are communicating
with the rf magic configuration software, but when connected to the pro mini and my windows 10 laptop
they dont seem to talk to each other. Note; using a usb adaptor on the pc end, and tying into the
ttl interface on pro mini, simple serial print sketch, any one out there have any experience with these
rf devices, this is basically a test circuit. Thanks for listening!
arena, so I have a pro mini controller, and two apc220 Transcievers. I have configured the two
rf modules with accompaning software (RF Magic), they are both set the same and are communicating
with the rf magic configuration software, but when connected to the pro mini and my windows 10 laptop
they dont seem to talk to each other. Note; using a usb adaptor on the pc end, and tying into the
ttl interface on pro mini, simple serial print sketch, any one out there have any experience with these
rf devices, this is basically a test circuit. Thanks for listening!