Hello,
I am building a 4-bit non-sequential synchronous counter using SN4027BE JK Flip-flops. I have designed the circuit in multi-sim and it works as expected. However, after I built the circuit, the output that I am getting isn't right. After spending several days on this, I am not sure what other debugging methods I should try. I am sure that my circuit logic is correct, the 555 timer I'm using to power the clock works properly, and even tried inverting the timer for some of my clocks since my IC chip is a master-slave flip flop.
Any insight or information will be greatly appreciated.
I am building a 4-bit non-sequential synchronous counter using SN4027BE JK Flip-flops. I have designed the circuit in multi-sim and it works as expected. However, after I built the circuit, the output that I am getting isn't right. After spending several days on this, I am not sure what other debugging methods I should try. I am sure that my circuit logic is correct, the 555 timer I'm using to power the clock works properly, and even tried inverting the timer for some of my clocks since my IC chip is a master-slave flip flop.
Any insight or information will be greatly appreciated.
Attachments
-
35.6 KB Views: 26