I'm trying to switch a low KHz square wave (4-6KHz 70-90V nominal) using a DC trigger signal, 12V would be convenient, but I can step up the voltage if necessary, a triac seemed like the correct device to accomplish this, however I seem to have a knack for using transistors incorrectly, and destroying them in the process, so I figured I would ask how I need to wire up this triac in order for it to function like a relay.
https://www.digikey.com/en/products/detail/stmicroelectronics/T2535T-8T/13559154
I don't know if it can control high frequency AC or not, the datasheet doesn't really say, if it can, it's massive overkill because it should only be switching a couple amps, and if it has a heatsink it's max voltage is around 10X what it should be switching.
https://www.digikey.com/en/products/detail/stmicroelectronics/T2535T-8T/13559154
I don't know if it can control high frequency AC or not, the datasheet doesn't really say, if it can, it's massive overkill because it should only be switching a couple amps, and if it has a heatsink it's max voltage is around 10X what it should be switching.