Hi...
I wanted to check if a couple of flip flops I have here are working properly. To accomplish that I was trying to verify the truth table but I'm having some issues in understanding how this works.
What I already did was to check the datasheet which is here.
In terms of connections I have the following:
Pin 16 (VDD) --> 12V DC
Pin 8 (VSS) --> GND
Pin 13 (CLK1) --> 100Hz Arduino square signal with 5V of amplitude
Now, the truth table works with J1 and K1 pins and will set Q1 and not Q1 to 0 or 1, accordingly, no??? Is that it?
I wanted to check if a couple of flip flops I have here are working properly. To accomplish that I was trying to verify the truth table but I'm having some issues in understanding how this works.
What I already did was to check the datasheet which is here.
In terms of connections I have the following:
Pin 16 (VDD) --> 12V DC
Pin 8 (VSS) --> GND
Pin 13 (CLK1) --> 100Hz Arduino square signal with 5V of amplitude
Now, the truth table works with J1 and K1 pins and will set Q1 and not Q1 to 0 or 1, accordingly, no??? Is that it?