i need a Switch Mode Supply.specification are given blow

Input voltage 220 AC

Output voltage 12 DC

Current 10 A


plz give me the circuit diagram of the above specification and one thing is important that this is a Switch Mode Power Supply.

 

Are you sure you want to go down to 12vDC?

If this is for your streetlamp design, you will be better served using a higher voltage for those 800 leds. Even jumping to 24v would be much better.

 

ok brother

i will try to use the 24 and change the circuit

now plz tell me the Schemetic diagram for

input 220VAC
output 24VDC
Currect 10A


must be a Switch Mode power supply

 

Naaw... I say go for 36V. less loss ....no..

 

I would have to agree, Rifaa. I would also go for 36V..at least. I was doing a little fumbling with his idea, and I am finding that a 48V supply would be optimal. He would save money with the gauge wire to use in the project and the leds would be happier longer. He wants a schematic for a smps at these voltages, but I am having a problem getting one together for him that he can get in Pakistan. Any ideas?

 

ok, i will try this

but send me the schemetic diagram of 48VDC

 

have to keep my mouth shut.....can't let any one know about this retched.
OP..I'll get you a schema...it will take a little time OK

 

ok.i am waiting your good replay.

plz mail me personaly i am very thankful to u

 

no emails...I'll post it here....we never hide what we share...

 

Hello,

On this page you will find sevaral links on SMPS:
http://www.educypedia.be/electronics/powerelectronicssmps.htm

Bertus