i am working on a project in which i have to control a stepper motor. earlier i was using L298n motor driver. it was working well until the stepper motor goes for holding. as it draws the maximum current which ultimately fry the driver module.
now i'm upgrading my project to new driver i search a lot and find tb6600 stepper motor driver quite good. now i want to know that will this problem come up again using tb6600 or not.
my stepper motor is mineaba motor 17PM-k406-11v which has 2.8 ohms per coil resistance and in data sheet recommended current is 1.4 amps which i have no idea how they are recommending this as 12volt/2.8ohms=4.3 amps approx per phase. please do guide me about tb660.
please do answer me ASAP!
now i'm upgrading my project to new driver i search a lot and find tb6600 stepper motor driver quite good. now i want to know that will this problem come up again using tb6600 or not.
my stepper motor is mineaba motor 17PM-k406-11v which has 2.8 ohms per coil resistance and in data sheet recommended current is 1.4 amps which i have no idea how they are recommending this as 12volt/2.8ohms=4.3 amps approx per phase. please do guide me about tb660.
please do answer me ASAP!