All About Circuits

Stacked patch antenna design

P

Thread Starter

Priyatharshini

Joined Feb 1, 2012
1
Hi..

I want to design stacked patch antenna by this spec...

Parameter---------Min------------Max-------- Description
arU------0.6------ 1.4------ Aspect ratio for the upper patch
xU-------20mm----68mm--- The x-dimension for the upper patch

arL------ 0.6------ 1.4------ Aspect ratio for the lower patch
xL------- 20mm----68mm--- The x-dimension for the lower patch

tL------- 0.1mm---10mm----Thickness of the lower dielectric layer
tU-------0.1mm---10mm--- Thickness of the upper dielectric layer
εU-------1.0------7.0------ Relative permittivity of the upper dielectric layer (μ_r=1.0)
εL------- 1.0------ 7.0------ Relative permittivity of the lower dielectric layer (μ_r=1.0)
xfeed----0.2mm---10mm----Distance of feed probe from the edge of patch

These are my spec.. want to design stacked patch antenna... plz help me... I am having MATLAB software... If u know the coding plz post here or send to my mail <SNIP>...


Thanks.........
 
Last edited by a moderator:
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
C Spacers for stacked PCBs PCB Layout , EDA & Simulations 11
L Stacked Peltier - Open Circuit General Electronics Chat 11
Juhahoo Power transfer through stacked PCBs? Ideas? Power Electronics 7
meowsoft Is 4x 5mm x 30mm Stacked Busbar is Enough for Earth Terminal Power Electronics 1
oidium45 "Balancing" or "matching" two variable autotransformers (stacked) Power Electronics 8
Similar threads
Spacers for stacked PCBs
Stacked Peltier - Open Circuit
Power transfer through stacked PCBs? Ideas?
Is 4x 5mm x 30mm Stacked Busbar is Enough for Earth Terminal
"Balancing" or "matching" two variable autotransformers (stacked)

You May Also Like

Top