Is it possible to connect the ST-LINK/V2 to a BLUENRG-M2SA. The data sheet swim connector has 4 pins VDD, DATA, GND, RESET. How do you hook it up to BLUENRG-M2SA with SWDIO and SWCLK? Is there a special IDE that you use with this set up. Cubemx does not support the BLUENRG-M2SA.

 

nope - you need to interface it to an arduino ---

 

That can't be right. I know it supports Arduino but there has got to have a programmer that works on it.

 

 

get the data sheet and spend some time trying to understand it
https://www.st.com/resource/en/datasheet/bluenrg-m2.pdf


Good luck -- Engineering is tough need to read ........

 

Here is what I think it should be