Hi guys,
I’ve got one for you. I’m trying to replace the small motor in an MG995 servo with a larger motor I pulled out of an 18v cordless drill. I’m trying to turn the cheap MG995 into a more powerful servo, without spending a lot of money on a more powerful servo.
I figured out the mechanics and how I want to attach the pot to the end of the drill motor. The trouble I’m having is hooking the motor up to the circuit board inside the MG995.
I thought I could use an H-Bridge, but that didn’t work, or maybe I hooked it up incorrectly. I will be controlling it with a raspberry pi. I just need help hooking up the H-Bridge between the drill motor and servo circuitry. Any help would be very appreciated at this point. Thanks in advance for your patience too.
I’ve got one for you. I’m trying to replace the small motor in an MG995 servo with a larger motor I pulled out of an 18v cordless drill. I’m trying to turn the cheap MG995 into a more powerful servo, without spending a lot of money on a more powerful servo.
I figured out the mechanics and how I want to attach the pot to the end of the drill motor. The trouble I’m having is hooking the motor up to the circuit board inside the MG995.
I thought I could use an H-Bridge, but that didn’t work, or maybe I hooked it up incorrectly. I will be controlling it with a raspberry pi. I just need help hooking up the H-Bridge between the drill motor and servo circuitry. Any help would be very appreciated at this point. Thanks in advance for your patience too.