Hi Everybody,

I will design a rectifier control card which will have the following properties:

- RS 485
- CAN BUS
- min 12 channels (pulse output)
- 3 phase
- External Digital Input (8)
- External Digital Output (8)
- Exterior Analog Input (VA)
- Exterior Analog Output (0 - 10V)

I'm planning to use Atmel as for microcontroller. Any idea how to design the above?

Ty/Red

 

Hi Everybody,

I will design a rectifier control card which will have the following properties:

I'm planning to use Atmel as for microcontroller. Any idea how to design the above?

Ty/Red

Really?? I thought you said "I will design"..

Do you have a specific question or do you really expect the internet to design it for you...?

 

Yes, no mean project, also you need to specify the digital I/O requirements in the way of V & I also whether isolated etc.
Max.

 

Really?? I thought you said "I will design"..

Do you have a specific question or do you really expect the internet to design it for you...?

Really? i thought this was a technical forum, not a philosophy forum.

 

No it's a forum where lazy people try to get others to do their work, and when the lazy person has to do anything himself he gets rude. It's that kind of forum.

I'm sure if you show what work YOU have done, people will offer suggestions and help with YOUR work.

 

No it's a forum where lazy people try to get others to do their work, and when the lazy person has to do anything himself he gets rude. It's that kind of forum.

I'm sure if you show what work YOU have done, people will offer suggestions and help with YOUR work.

I don't understand why ppl mess up unless they have technical suggestions. I think this way is easier for lazy ppl to get attention.