So I've been working on updating a couple old circuit board designs to make use of SMT parts etc., and I'm almost to the point of being ready to find a board house that can make me a couple PCBs (open to recommendations to where I can send off the gerbers etc.)
Anyway, I just wanted to know what is the proper size for the bypass caps normally placed adjacent to ICs... I thought 0.1uF was the norm, but all the bypass caps on this logic board are 0.01uF? (as in marked '103' vs. '104')
Anyway, I just wanted to know what is the proper size for the bypass caps normally placed adjacent to ICs... I thought 0.1uF was the norm, but all the bypass caps on this logic board are 0.01uF? (as in marked '103' vs. '104')