I have next to zero experience designing complex circuits and have taken the plunge by attempting to design a circuit I can use to control an RC lawn mower. I was hoping someone would be willing to look over my design and at least confirm that it won't blow itself up. To the best of my knowledge 24 volt systems drawing high amperage can be rather dangerous.
There are a few unknowns in this system that I would like to point out:
There are a few unknowns in this system that I would like to point out:
- Exact wheelchair motor model has not yet been determined, so I don't have a specific value on amp draw of M1 and M2
- Exact model of motor controller has not yet been determined for the same reason as the above, but all the controller models function in the same manner
- Batteries will most likely be lead acid but total battery capacity has not yet been determined
Attachments
-
28.9 KB Views: 29
-
71.9 KB Views: 20