Hi there,
A bit of a newbie question here: I’ve programmed an Attiny to perform a single pulse on power-up, that is, when 3 volt is applied to the chip it simply sets a pin to HIGH (on void setup) and goes LOW during the loop. It works as expected, however, there seems to be a short lag during power-up and I need the pulse to be instant. Does anyone know how long it takes to boot the chip? Would it be a better idea to set the chip to sleep mode and just wake it up to perform the pulse and then go back to sleep? Or are there any smarter ways to do this?
A bit of a newbie question here: I’ve programmed an Attiny to perform a single pulse on power-up, that is, when 3 volt is applied to the chip it simply sets a pin to HIGH (on void setup) and goes LOW during the loop. It works as expected, however, there seems to be a short lag during power-up and I need the pulse to be instant. Does anyone know how long it takes to boot the chip? Would it be a better idea to set the chip to sleep mode and just wake it up to perform the pulse and then go back to sleep? Or are there any smarter ways to do this?