Thanks Papabravo,Any kind of MOSFET or H-bridge Motor driver will do the job
Thanks, but for high currents there are several. I need it for 30 or 40V and 30 to 100mA.You sure didn't try very hard.
How about this one at $2.00/piece; it's a BEAST!!
https://www.onsemi.com/pdf/datasheet/ncp51530-d.pdf
Yes you're right, it could never work. The way you present it is correct.Your circuit will not work.
Try this one:
You don't need to find a part the closely matches your requirement. You find one that meets or exceeds your requirement. As always, cost is a factor.Thanks Papabravo,
I did several searches but I can't find for 100mA and 28V for example. Only for very high currents. In the same project I will use 4 sets of outputs.
You know that the current rating is maximum current, right? It will still work at lower currents!Thanks, but for high currents there are several. I need it for 30 or 40V and 30 to 100mA.
My project connect to sink or source PLC inputs and PLC inputs is 24Vdc and abaut 10mA.
Sory IC Integrated CircuitWhat is a CI?
ak
by Duane Benson
by Aaron Carman
by Jake Hertz
by Jake Hertz