Proteus, Arduino control of a stepper motor with L297 and L298

Discussion in 'Homework Help' started by Dorian Poissonnet, Mar 1, 2018.

  1. Dorian Poissonnet

    Thread Starter New Member

    Mar 1, 2018

    First of all sorry for my bad english but I need help to finish my school work.

    I have to propose a cabling and a flow chart in Proteus to run a stepper motor with an angle which measure 20° in 10 secondes.
    Nominal Volt : 3.8 / Step Angle : 0.25 / Max RPM : 360 / Coil Resi : 5.6 / Coil Induc : 4mH

    I tried to do since 4h but I don't understand, can someone explains me how does this work ?
    Here is my diagram...