Hello,I have the HMC8193 component shown in the data sheet below .
I know the maximal rating where the component could burn.
Where can I see the normal power levels where this device is designed to work at?not being compressed.
Thanks.

https://www.analog.com/media/en/technical-documentation/data-sheets/hmc8193.pdf

 

Drive level: 18dBm

I think that is what you are after.

 

Hello , Yes i understand Lo needs to be 18dBm.
What about the IF1 IF2 ,RF ports, there is no data regardin the exact values it can operate in.

If Lo=18dBm and I am upconverting What power levels i need to keep plan for IF1 IF2 ,RF ports

 

UPDATE:
Hello, I took the table bellow from page 30 in the data sheet.
suppose i have one tone in IF which is upconverted to RF.LO=18dBm.
Given the table how do I know what is the IF1 IF2 RF power levels in such case?
Thanks.
https://www.analog.com/media/en/technical-documentation/data-sheets/hmc8193.pdf

 

Update:

Hello , given IF signal 500Mhz 5dBm,LO is 6Ghz 18dBm ,two questions:
1. So given these conditions RF main tone is 6.5Ghz and 5-8=-3dBm correct?
2.What are the power values of IF and LO which I can expect the RF signal to be compressed?(in up conversion)
Thanks.


https://www.analog.com/media/en/technical-documentation/data-sheets/hmc8193.pdf