Hi all
I am doing a simulation of a simple circuit, then I try to measure DC current as my image.
My problem is that I am not clear why there is a difference in DC current values, even though I applied same Voltage (5V) and the same resistor (250 Ohm).
Anyone plz help me to recognize my fault.
TIA

 

The IQadj pin should be connected by the resistor to -5V, not +5V.

 

The IQadj pin should be connected by the resistor to -5V, not +5V.

Hello AlbertHall
Even though I ex-changed position of Resistor and AmperMeter, but current value was still ~134uA.

I think that current value obeys to Ohm law, and it should be 5V / 250Ohm = 20mA

 

That doesn't look like an LTspice simulation.
Is it Electronics Workbench?

 

What makes you think that the voltage across R1 is 5V?

 

That doesn't look like an LTspice simulation.
Is it Electronics Workbench?

Yes, I used TINA-TI simulator.

 

What makes you think that the voltage across R1 is 5V?

Oh, I got it.