I apologize in advance. I know this but keep getting confused.
I have a 5000mAH NiMH C cell battery pack. With it I’m powering an Arduino, Amplifier shield and a servo shield. There are a couple of LEDs and four servos. I purchased a charger with the battery pack.
I suspect most of that detail is irrelevant.
Do I need to diode isolate the charger? Or can I charge while everything else is connected?
I could wire the power switch so that the charger is disconnected while the remaining circuitry is connected.
?
I’ve confused myself and clarification is welcome. Op
I have a 5000mAH NiMH C cell battery pack. With it I’m powering an Arduino, Amplifier shield and a servo shield. There are a couple of LEDs and four servos. I purchased a charger with the battery pack.
I suspect most of that detail is irrelevant.
Do I need to diode isolate the charger? Or can I charge while everything else is connected?
I could wire the power switch so that the charger is disconnected while the remaining circuitry is connected.
?
I’ve confused myself and clarification is welcome. Op