I seem to recall a post recently where someone was trying to locate power resistors with stand off support.
I recently had an issue when looking for similar replacement but did not have much time to seek one out.
I had some power resistors that were meant to be mounted vertically with a channel in one side and board clips.
In order to replicate the original style, I came up with some improvisation.
The pictures tell the story, the muffler cement sets up pretty hard!
14g Copper wire used for support & conductor. Tin from a coffee can trimmed to suit slot and soldered connection.
Max.
I recently had an issue when looking for similar replacement but did not have much time to seek one out.
I had some power resistors that were meant to be mounted vertically with a channel in one side and board clips.
In order to replicate the original style, I came up with some improvisation.
The pictures tell the story, the muffler cement sets up pretty hard!
14g Copper wire used for support & conductor. Tin from a coffee can trimmed to suit slot and soldered connection.
Max.
Attachments
-
320.7 KB Views: 28
-
319.1 KB Views: 29
-
317.4 KB Views: 28
-
315.6 KB Views: 26
-
322.5 KB Views: 24