Picking inductor and capacitor values for an RF circuit

Thread Starter

Avshi

Joined Jan 16, 2015
48
Hello, i'm working on a automation project that requires wireless connectivity. I'm using some design notes (attached) and it says that I have to pick these values based on the frequency that I want to use (868MHz), but I'm not sure that I know what values would work well. My research on this topic has yielded little and I would appreciate any literature recommendations so that I may edumacate myself and rely slightly less on you wonderful internet people. So, help picking these values and maybe an appropriate rf switch would be appreciated.
 

Attachments

Thread Starter

Avshi

Joined Jan 16, 2015
48
Thanks for the answer, I read through these docs and was still stumped. I ascertained that the tx pin is preceded by a matched filter and then a low pass filter and then I found an application note that specifies values for all of the components I was wondering about soooo that kinda ends this thread:rolleyes:.
Thanks again.
 
Top