Hi, I would like to ask how do I place my power and output connector on my PCB. And also, any suggestions to improve my design?
Attachments
-
49.1 KB Views: 36
-
107.5 KB Views: 35
Do you mean where?how do I place my power and output connector on my PCB.
You haven't given us much to critique. At first glance, you have too much space between the components and could easily reduce area by about 50%.And also, any suggestions to improve my design?
is this better?General speaking,
Keep power input and signal out on opposite sides of the board,
route the design as you have the schematic laid out is a good start point.
A definite improvement. Route it and see if you find more optimal placements for some of the components in the lower right.is this better?
by Jake Hertz
by Aaron Carman
by Jeff Child