So I'm not overly happy, I brought a cnc controller for a project, as you can probably guess I'm building a cnc router.

I brought the akz250 I hope it was going to be a decent controller (£60), but it all started when asked for a .bin file when connected to mach3, after talking to the seller for 2 weeks they finaly provide me with the .bin file and some instructions to follow.

So I followed the instructions and uploaded the .bin file and now iv lost all communication with the controller, when checking the status of the connection the computer is sending packets but not receiving anything, iv doubled checked the setup and everything seems to be fine.

I'm guessing this is not a hardware issue but a programing/firmware related issue.

As you can guess I'm not getting any response from the seller now and its been over 3 months.

I'm just wondering if anyone has any ideas on what I could try to get it working again or even a way to use it even.

Thanks for any help or advice

 

hi 474,
Have you seen this link.?
http://leafboy77.com/?page_id=25

E

 

hi 474,
Have you seen this link.?
http://leafboy77.com/?page_id=25

E

Sorry I put the wrong controller as the title iv changed it now