All About Circuits

Need help with strain gauge bridge

Search Forums New Posts
K

Thread Starter

Kunjalata

Joined Aug 6, 2014
1
Hello!
I have used Quarter bridge using strain gauge whose nominal resistance is 350ohm and Gauge factor is 2.13+1%. The bridge is excited by 1KHz,1V(p-p) sine wave signal. The bridge output for DC excitation is Vout=(Vin/4)ΔR/R.Is the same formula for AC excitation? Please give the correct answer.
 
Last edited by a moderator:
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
I Need help for close-loop scalar control of induction motor Homework Help 7
M Need help with ADuM4221A in 13.56MHz RF power amplifier design Analog & Mixed-Signal Design 48
C Need help identifying this header. Datasheets, Manuals & Parts Identification 1
muhammadanas25 Need Help Designing Power Management Circuit for Production-Ready 2G GPS Tracker (SIM800L + ESP32-C3) Power Electronics 1
B-JoJo-S Need input (not Johnny 5). This gate symbol; I don't understand. Please help General Electronics Chat 11
Similar threads
Need help for close-loop scalar control of induction motor
Need help with ADuM4221A in 13.56MHz RF power amplifier design
Need help identifying this header.
Need Help Designing Power Management Circuit for Production-Ready 2G GPS Tracker (SIM800L + ESP32-C3)
Need input (not Johnny 5). This gate symbol; I don't understand. Please help

You May Also Like

Top