This is probably a really simple problem, but I have recently quickly soldered up a switch inside my jeep to go to a garage clicker behind the steering column. It works, but I decoder ef an led at the top of the clicker's circuit card, and Burt the original doddering points. I would like to know if there is a way to still set up the led in this existing circuit?

 

…but I decoder ef an led at the top of the clicker's circuit card, and Burt the original doddering points.

Huh? English please. I'm assuming that autocorrect mangled your question.

 

Huh? English please. I'm assuming that autocorrect mangled your question.

Yeah autocorrect did kinda destroyed that sentence. I meant to say that I desoldered the led off of the top of the card, and burnt the soldered led points.

 

The owners of All About Circuits has elected not to host discussions of automotive electrical system modifications/enhancements due to safety concerns, the potential of legal ramifications and the possible circumvention of vehicle regulations at the state and federal level.

This thread is against the AAC forum rules, Chapter 6, as seen here:

6. Restricted topics. The following topics are regularly raised however are considered “off-topic” at all times and will results in Your thread being closed without question:

• Any kind of over-unity devices and systems
• Automotive modifications
• Devices designed to electrocute or shock another person
• LEDs to mains
• Phone jammers
• Rail guns and high-energy projectile devices
• Transformer-less power supplies

This can be found in our Terms of Service (ToS)

Automotive modifications of any kind are strictly forbidden. Therefore, this thread will be closed.

Please try to understand the reasons behind this action, and feel free to browse and use the forums.

You might find answers to your questions in one of these forums:

http://forum.allaboutcircuits.com/showthread.php?t=54400

Another good forum that shares many of the same membership is http://www.electro-tech-online.com/ . Good luck.