4.5 Use the Bias Point Analysis command to find V1 in fig. 2 if Vs is increased from 10 V to 20 V in 2 V increments.
http://img191.imageshack.us/i/52761985.jpg
Here is what I have so far
http://img607.imageshack.us/img607/3137/19308845.jpg
How do I properly connect the Dependent Sources? Also what is the equivalent of Bias Point analysis in Multisim? Is the whole "increasing Vs in 2V increments" done in that analysis?
http://img191.imageshack.us/i/52761985.jpg
Here is what I have so far
http://img607.imageshack.us/img607/3137/19308845.jpg
How do I properly connect the Dependent Sources? Also what is the equivalent of Bias Point analysis in Multisim? Is the whole "increasing Vs in 2V increments" done in that analysis?