Hey guys, I dont know much about this stuff and Im looking for a little help.
I want to have a small quantity of tiny chips/boards made to trigger button on a previous existing board. Its the button in red. I guess Im having a hard time tracing it out. Im not sure what the black stuff is that the trace runs into. Is it just where a bunch of traces run together? Or is there some type of controller in there?
My ideal plan was to make the chip connect of the other end of the cable. Im having a hard time making the trace since I can't see under the black area. If there is some sort of control in there I dont think I would be able to grab it from the far end of the cable then.
Any help would be great.
I want to have a small quantity of tiny chips/boards made to trigger button on a previous existing board. Its the button in red. I guess Im having a hard time tracing it out. Im not sure what the black stuff is that the trace runs into. Is it just where a bunch of traces run together? Or is there some type of controller in there?
My ideal plan was to make the chip connect of the other end of the cable. Im having a hard time making the trace since I can't see under the black area. If there is some sort of control in there I dont think I would be able to grab it from the far end of the cable then.
Any help would be great.
Attachments
-
550.1 KB Views: 14
-
741 KB Views: 14