Hi,
Need help identifying this type of component. I'm guessing it's a resistor network, but can't find anything on it.

Thanks for the help in advance

Moderators note : cropped image

 

Can you check resistance with a multimeter?

 

Most likely a custom resistor network: https://www.ctscorp.com/products/specialty-resistors/resistor-networks-rc-terminations/ They could be connected in all sorts of ways. Sometimes these are used in DMM ranging applications or terminators.

Example: https://www.mouser.com/ds/2/96/770-786259.pdf

But not your part.

So, it could be a thick film of interconnected resistors.

Might help to know what it was used in.

So, best guess is a custom part from CTS and likely a resistor network.

 

Just to confuse things, it also can be a bunch of resistor-capacitor networks. What is it from? Photos of the board? Any clues about the type of circuit it is in?

ak

 

Thanks for the help so far.

I received a bunch of these without label and have no idea what the application was for. I did bring out the DMM and measured the resistance (Black box is the ground lead)

 

Thanks for the help so far.

I received a bunch of these without label and have no idea what the application was for. I did bring out the DMM and measured the resistance (Black box is the ground lead)

If the coloured pair readings marked below are repeatable then there are semiconductors in there so you aren't going to be able to decode what they are.