Is there a way in which I could set up a circuit that is controlled by a switch to switch between charging a 7.4V LiPo with a micro-USB board breakout and using the LiPo to power my robot?
Thanks
Thanks
Multicell LiPo Charging and Use
- Thread starter MontyPylon
- Start date
| Thread starter | Similar threads | Forum | Replies | Date |
|---|---|---|---|---|
|
Multicell Battery Stack Monitor IC | Power Electronics | 0 | |
|
DW01A in overdischarge protection mode and TP4056 won't start charging it | Power Electronics | 2 | |
|
What is going on with these Earbuds? | General Electronics Chat | 14 | |
| J | Lipo battery question | Technical Repair | 2 | |
| N | 3 wire 7.4 volt 2 cell lipo Battery | Power Electronics | 13 |
