hi is there any version of multisim which you can in sert a j operator value e.g. an inductor with the value of +j 12

or cacitor with value -j32

thanks

bob

 

If multisim is a circuit simulator. It will take care of this for you. So just use component value. In Pspice you can use these component suffix. I think they are legal in multisim also. They may also case insensetive (I think not sure )
PSPICE Power-of-Ten Suffix Representation:
F fento- 10-15
P pico- 10-12
N nano- 10-9
U micro- 10-6
M milli- 10-3
K kilo- 10+3
MEG mega- 10+6
G giga- 10+9
T tera- 10+12
MIL (0.001") 25.4×10-6

 

if i want to make a circuit using j values can i ?

 

No I do not think so. But why do you want to this? Do want to simulate closed loop system? For that kind of simulation it is better to use Control Design and Simulation software tools

 

to check my complex number calulations

 

Most modern scientific calculators are able to do that form of calculation quite easy.