Hello
I wish to modify the Hall effect up down switches on a cheap LCD display which use a magnet connected to the gear change and two Hall effect sensor
to a run decade counter
I wish to use six outputs to connector to the six wires that feed the digital dash LCD
So each wire will need 2 volts depending on which gear it's in
So it's an up down counter using the neutral switch to show zero
Any help would be appreciated
Regards
Keith Tait
I wish to modify the Hall effect up down switches on a cheap LCD display which use a magnet connected to the gear change and two Hall effect sensor
to a run decade counter
I wish to use six outputs to connector to the six wires that feed the digital dash LCD
So each wire will need 2 volts depending on which gear it's in
So it's an up down counter using the neutral switch to show zero
Any help would be appreciated
Regards
Keith Tait