Happy New Year to everyone!
i figured since there have been some members already talking about the MC-2000 controller I may ask for some help.
So I my uncle called to check his Threatmill which stopped working partly.
Basically it working fine meaning its display, logics and vertical motor etc.
However when I increased the running speed the belt would not move at all.
I opened up the covers and found the MC-2000 board complete off. Meaning no LED was on even though the AC 230 V was connected to the board (measured the voltage).
Do you folks have any idea what the reason could be? Could the varistor (MOV) be damaged so the board can not power up?
I have included two pictures.
best regards
Ben
i figured since there have been some members already talking about the MC-2000 controller I may ask for some help.
So I my uncle called to check his Threatmill which stopped working partly.
Basically it working fine meaning its display, logics and vertical motor etc.
However when I increased the running speed the belt would not move at all.
I opened up the covers and found the MC-2000 board complete off. Meaning no LED was on even though the AC 230 V was connected to the board (measured the voltage).
Do you folks have any idea what the reason could be? Could the varistor (MOV) be damaged so the board can not power up?
I have included two pictures.
best regards
Ben
Attachments
-
1.9 MB Views: 19
-
1.2 MB Views: 18