I want to switch a heavier load that has its own battery with a micro controller. A n-mosfet should do that just fine, but to avoid soldering too much I am looking for a ready made solution like the one below:

https://www.freetronics.com.au/coll...ts/n-mosfet-driver-output-module#.WYmqT4iGOGV

These are great, but made in Australia. has anyone seen this somewhere in Europe, US, or something similar?

 

Hello,

Why not go for a TO 220 mosfet?
http://www.newark.com/stmicroelectronics/stp40nf10l/n-channel-mosfet-100v-40a-to-220/dp/26M3697

Bertus

 

Don't see how that avoids any soldering.

Bob

 

Don't see how that avoids any soldering.

Bob

Even with your board you will need to solder wires to it.
How about something like this: http://www.ebay.co.uk/itm/IRF520-Dr...076791&hash=item2a8794f6e1:g:joEAAOSwOjBZZOW6