Hi, this isn't an easy question to phrase, but essentially I'm looking at using momentary switches to control which headphone jack (3 total) the input audio will be diverted to. Ideally, I would like the selected output to be the only output - ie, if output 1 is active, then the button for output 2 is selected, output 1 becomes inactive and output 2 stays on.
I understand the basics of turning a momentary switch into a latching one (have "achieved" this before using circuits found online), but that method was used as a power switch, where the calculations were simpler. On top of this, the plan I have also requires the original latch do be deactivated. I understand that this might be seen as a bit of a jump in terms of complexity, but I was wondering if anyone would be able to point me in the right direction on this project I have planned.
Thanks in advance
I understand the basics of turning a momentary switch into a latching one (have "achieved" this before using circuits found online), but that method was used as a power switch, where the calculations were simpler. On top of this, the plan I have also requires the original latch do be deactivated. I understand that this might be seen as a bit of a jump in terms of complexity, but I was wondering if anyone would be able to point me in the right direction on this project I have planned.
Thanks in advance