Hello,
I have an ESC which is rated for 40A. I want to make sure that the 3 phase motor to which it is connected is getting sufficient voltage. How do I connect my multimeter to the ESC to measure voltage correctly? Should I just run the ESC at 80% PWM and measure 2 of the 3 outputs from the ESC? I once heard that you could short the ESC and/or the multimeter if this is done incorrectly so I thought I would make sure I was doing it right before connecting anything.
ESC: https://hobbyking.com/en_us/ztw-spi...pto-multi-rotor-esc-2-6s-simonk-firmware.html
Motor: https://hobbyking.com/en_us/4112-32...-multi-rotor-motor-with-extra-long-leads.html
Thanks!
I have an ESC which is rated for 40A. I want to make sure that the 3 phase motor to which it is connected is getting sufficient voltage. How do I connect my multimeter to the ESC to measure voltage correctly? Should I just run the ESC at 80% PWM and measure 2 of the 3 outputs from the ESC? I once heard that you could short the ESC and/or the multimeter if this is done incorrectly so I thought I would make sure I was doing it right before connecting anything.
ESC: https://hobbyking.com/en_us/ztw-spi...pto-multi-rotor-esc-2-6s-simonk-firmware.html
Motor: https://hobbyking.com/en_us/4112-32...-multi-rotor-motor-with-extra-long-leads.html
Thanks!