I have searched all over and have not found an answer. I am a newbie, please bear with me, I'll try to explain as best as I can.
I have an alternator which I assume has a 3 phase wye configuration. I am planning on removing the rectifier. I would like the alternator to supply power when it is...
Hey, I am working on a project that requires a 3 phase AC motor using a speed controller that has a 1 phase input and a 3 phase output. I am trying to wire an emergency button that will stop it immediately or quickly as possible. Do yall have any suggestions on parts or wiring diagrams? thanks.
Hello,
I have an ESC which is rated for 40A. I want to make sure that the 3 phase motor to which it is connected is getting sufficient voltage. How do I connect my multimeter to the ESC to measure voltage correctly? Should I just run the ESC at 80% PWM and measure 2 of the 3 outputs from the...
Hi there,
In order to achieve unity power factor control, the phase of the AC voltage needs to be obtained. The phase is obtained through a phase-locked loop (PLL).
Take a look for single phase control structure of the PLL ,
For such similar way I want to mention some of 3-phase equations...
Hello everyone ...
For a project, I want to make an escalator smart with a number of PIR sensors
So that the escalator turns off after one minute of not using it
And for example, turn on 20 seconds later
If this cycle continues, can it damage the engine?
The specifications of this motor are 9 kW...
hello everyone , for a project i must calculate the exact energy that used for start of motor until the motor return to normal work
in other words how much energy use for normal work of this motor equals the starting energy ?
the motor is 3 phase 20 Ampere 9KW
unfortunately i have no complete...
Asking for some advice as I can't seem to find anything. I have been asked if there's any way to run a 3 phase fryer from a single-phase supply. I've attached some images below.
any idea for rewiring would be appreciated
I looked at a variable frequency drive but to my understanding, it...