Hi, Looking for Mackie CR3 & CR5 Schematic. Or any help to identify zener diode Z4 in the CR3 circuit. The CR3 is made by LOUD Technologies.inc. But I have been told it used to be Mackie. Any help very appreciated.
Mackie CR3 & CR5 Schematic Wanted
- Thread starter Angel_Chaser
- Start date
I believe what you are looking for is a Zener Diode Z4 is a 1N4742A - 1w 12V
Thanks for info. Do you happen to have the schematic? Thanks again...
Look here:
https://forum.allaboutcircuits.com/threads/mackie-cr3-speakers-muting.151787/
and here:
https://forum.allaboutcircuits.com/threads/mackie-cr3-service-manual.152960/
It pays to look at Similar threads at the bottom of this page.
https://forum.allaboutcircuits.com/threads/mackie-cr3-speakers-muting.151787/
and here:
https://forum.allaboutcircuits.com/threads/mackie-cr3-service-manual.152960/
It pays to look at Similar threads at the bottom of this page.
| Thread starter | Similar threads | Forum | Replies | Date |
|---|---|---|---|---|
| P | Powering a Mackie mixer (18vac 1A) on 32x AA batteries? | Power Electronics | 14 | |
| A | Mackie CR4BT speaker repair | Technical Repair | 11 | |
| C | Mackie ProFX8 mixer - Low gain fault | Technical Repair | 6 | |
| B | Mackie SRM350 v3 | Technical Repair | 9 | |
| A | Mackie CR4 (probably Zenner diodes burned.(2) | Technical Repair | 3 |
You May Also Like
-
ST Releases Flagship Low-Power MCUs and New Process Technology
by Jake Hertz
-
Renesas Rolls Out Entry-Level MCU With ‘Best-in-Class’ Power Consumption
by Jake Hertz
-
Novosense Releases Higher-Performance Op Amps for Automotive
by Jake Hertz
-
Wi-Fi HaLow Flexes Its Wings, Extending Two Miles on Morse Micro SoC
